burty Posted March 20, 2022 Share Posted March 20, 2022 6 hours ago, Starletson said: Thanks guys 🙂 Rust and paint need sorting next Get your wallet out mate i feel your pain Quote Link to post Share on other sites
Starletson Posted March 21, 2022 Author Share Posted March 21, 2022 On 3/20/2022 at 9:14 AM, burty said: Get your wallet out mate i feel your pain Almost as painful as a full tank of gas 😉 Quote Link to post Share on other sites
Starletson Posted April 2, 2022 Author Share Posted April 2, 2022 Quote Link to post Share on other sites
Starletson Posted April 8, 2022 Author Share Posted April 8, 2022 Yay 😒 Quote Link to post Share on other sites
Starletson Posted April 20, 2022 Author Share Posted April 20, 2022 Back on the road 😎 Quote Link to post Share on other sites
Pikey009 Posted April 22, 2022 Share Posted April 22, 2022 Boom, good effort, no mention of the rust so it can’t be that bad 🙈 Quote Link to post Share on other sites
Starletson Posted April 26, 2022 Author Share Posted April 26, 2022 Lol 😆 Well it had a melted headlight bulb and the emissions were sorted by unplugging the lambda sensor 🤣 Quote Link to post Share on other sites
Starletson Posted May 7, 2022 Author Share Posted May 7, 2022 Bit of DIY. Hammerite smooth silver. What could go wrong right? 🤔 Quote Link to post Share on other sites
Starletson Posted May 7, 2022 Author Share Posted May 7, 2022 Got over spray on my phone screen 🤣 Quote Link to post Share on other sites
Goldie Posted May 8, 2022 Share Posted May 8, 2022 Just been reading through this, nice build dude, keep it up. What's next? Quote Link to post Share on other sites
Starletson Posted May 8, 2022 Author Share Posted May 8, 2022 And on 😎 Quote Link to post Share on other sites
Starletson Posted May 8, 2022 Author Share Posted May 8, 2022 (edited) 12 hours ago, Goldie said: Just been reading through this, nice build dude, keep it up. What's next? Probably need to sort out the paintwork, the passenger door is getting bad on the bottom corner and the rest of the car is in need of some tlc. Rear drums and front calipers could do with a lick of paint, so could some engine bay brackets. Glanza front brakes would be a nice addition, may just upgrade these original discs and pads when the time comes. Rear wheel bearings need doing and the rear shocks may need replacing Got some 303 to spray on the rubbers Need to clean the grime off the side of engine as I'm getting some belt slippage and the annoying sqweek I've replaced all the headlight bulbs with some phillips ultra white aswell May take a wire wheel to the rocker cover and see how that turns out Edited May 8, 2022 by Starletson More content Quote Link to post Share on other sites
RWDM47 Posted May 26, 2022 Share Posted May 26, 2022 On 3/4/2022 at 1:21 PM, Starletson said: Intake on 😁 Was that a straight bolt on? Videos and other posts I seen you had to mess around with the throttle cable and putting in washers for it all to fit etc but it looks the same as standard in this pic Quote Link to post Share on other sites
Starletson Posted June 13, 2022 Author Share Posted June 13, 2022 My mechanic put it on. As far as I'm aware it went straight on. I wasn't there when he installed it Quote Link to post Share on other sites
Starletson Posted February 21, 2024 Author Share Posted February 21, 2024 Off to Devon this weekend to get some doors and a v boot lid with v wang 👍🏻 Quote Link to post Share on other sites
akyakapotter Posted February 22, 2024 Share Posted February 22, 2024 My neck of the woods Quote Link to post Share on other sites
Starletson Posted April 19, 2024 Author Share Posted April 19, 2024 Didn't get the bits in the end, weather was shite and flooded roads etc. Getting her MOT'd soon. Can anyone confirm if I need Glanza calipers to upgrade the front brakes? Or just the pad carriers? Quote Link to post Share on other sites
Starletson Posted August 25, 2024 Author Share Posted August 25, 2024 She looks sad 😪 Finally got a passenger door! Just need to fit it 🤣 que wonky door 🤪 Been in for new discs and pads and had rear bearings done. In for MOT on 2nd Sept 🤞🏻 Quote Link to post Share on other sites
Starletson Posted August 25, 2024 Author Share Posted August 25, 2024 (edited) What would be the pros/cons plus parts required to turbo the 4e versus chucking a 5e in her? Does the 5e just need the engine and a 5e engine management and bobs your uncle? Edited August 25, 2024 by Starletson Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.