Jump to content

Ollieh17

Member
  • Posts

    5109
  • Joined

  • Last visited

Everything posted by Ollieh17

  1. it shouldn't really matter as you have a jam ecu so no fuel cut
  2. fair. They look like they may work but depends on the tap i suppose. I know my taps at home are retardley shaped. I'd tell him to get an outside tap plumbed in too
  3. i'd be very interested in this
  4. depends on the tap http://www.hozelock.com/watering/hose-fittings/connect-to-tap.html (google is your friend)
  5. theres a company by me that can order in ksports
  6. mine went and just replaced the whole driveshaft, if you can get one with good cv boots it'll probably work out cheaper and easier to do
  7. actuator sold, coilovers will be off this weekend
  8. anyone having issues today?
  9. i was right then i had the same, just wrapped it in electrical tape
  10. can you post them?
  11. ah fair, still may be interested in the three point
  12. depending how the MOT goes i might take these, if still around in a week or so
  13. are the rear seats in good condition?
  14. I would if you havent got aircon, makes everything so much easier
  15. Its very awkward to get to if you've still got aircon pump fitted. Otherwise still a bit awkward to get the angle for the thread and banjo bolt but not hard
  16. so nice, one of the few with a TOMS bumper, think i asked you before how they are attached in? Dying to know. Also are they 96 or 98 spec fogs
  17. welcome bud, not too far from me. I have a hks actuator if interested
  18. bump, mot soon and need to replace the front shock but rather get coilovers
  19. Fair enough, mine used to sound like that when booting it and i thought it was a leak. Then the turbo completely died, shitting oil all in the intercooler pipes
  20. theres a TOMS on ebay for £110 buy it now
  21. around 6-9 secs that sounds like a leak to me. Sounds too high pitch to be spool. Didn't you have a problem with a leaking dumpvalve?
  22. To fit mine: i jacked it up and fitted from underneath, attach to the turbo and bolt up loosely then attach the other end to oil feed on the block. Tighten them all up
  23. yeh they should be fine
×
×
  • Create New...