Jump to content

Ollieh17

Member
 View Profile  See their activity

  • Posts

    5109

  • Joined

  • Last visited

 Content Type 

Everything posted by Ollieh17

  1. Ollieh17
    Join a forester page and ask about, avoid the starlet tax then
  2. Ollieh17
    Saw some of the gt20 are ball bearing?
  3. Ollieh17
    GT1752s is the one i have. Saab 9-3. There is alot of different flange arrangements but not many different cores etc
  4. Ollieh17
    Gt17 basically uses t25 flange which is pretty common and again opens up to a wide range of turbos
  5. Ollieh17
    Be nice to see people try other turbos. I reckon GT17 or a GT20 would be a good turbo. GT17 populat on mini turbos using the 1.3. On my 1.0l 3 pot full boost (0.8)by 3750ish
  6. Ollieh17
    Hopefully we'll get a good trade agreement with Japan
  7. Ollieh17
    Euro against yen has dropped too?!?
  8. Ollieh17
    Just stick it on facebook hassle free
  9. Ollieh17
    Piston rings could be fine though and just have issue with an oil control ring
  10. Ollieh17
    Ive compared one when i needed one. Still arent dampened
  11. Ollieh17
    If you are going to get all the bottom end balanced with a 4efe one go for it.
  12. Ollieh17
    I highly doubt it is dampened for £40 doesnt even look like it is.
  13. Ollieh17
    Better off with a chipped 4efte one than a good 4efe
  14. Ollieh17
    Journal bearings dont really need restrictiors, escpecially on a new, journal bearing turbo.starlets dont really run high oil pressure and the oil feed i imagine is around 4an so that provides a restriction. Have you checked your oil drain setup? Only blockages? Uphill areas? Tight bends?
  15. Ollieh17
    Similar things to spec tbh. Also issues with them not fitting properly and catching bellhousing
  16. Ollieh17
    technically wrong one for 4efte
  17. Ollieh17
    I've always done it by eye and never had an issue.
  18. Ollieh17
    Harmonically balanced and harmonically dampened are different things. 4efe isnt dampened. Tbh most will have chips in and dont really affect it
  19. Ollieh17
    Ive seen bad things about comp clutches too
  20. Ollieh17
    Loose or oil/water getting on it
  21. Ollieh17
    As much castor as possible
  22. Ollieh17
    My glanza made this noise
  23. Ollieh17
    chances are they won't work properly with the right bias valve. Awful awful brakes
  24. Ollieh17
    Left over oil from old core?sure its defo burning oil?
  25. Ollieh17
    Try it, engines are cheap
×
×
  • Create New...