Duduglanza

Give a good clean to the idle control valve . It takes care of the idle while the engine is cold.

Yes if the thermostat is stuck closed.. it will overheat...

Noo

Didnt understand

Speedo and tacho working fine?

It shows everytime you drive your car or every now and then? Mine shows up every now and then.. most of the time it do it while im on 5th and boost is building slowly...

How can I order syncro if i dint know if its a c52 or c56 gbox? Is there any differences?

Will check again..

Im running an emanage ultimate therfor it modified . It only flashes it rarely. Everything works fine..

Whats the point you need to retard 2 degrees?

Sometimes it pops this code.. whats exectly the reason?

No im noy using detcans altough im doing a pair right now.. The knocking noise loud enough to hear it by ear while reving. I might be worrying for nothing as it only knocks for a second in the 3000rpm range.

Sure not bearing knock..while accelarating on low boost going 13.2 .. high 12s.. low 11s when hitting 21psi Maybe just my mind!

Im not sure of this but when im accelarating i sometimes hear some knocking/ping. I have forged wossner pistons and by them selves they already make strange noisestill they heat up but its common as i know others. How can i be sure the engine is not knocking/pinging? Should i retard ignition by a bit and see if it does it or any other method?

Maybe the gauge isnt giving you the correct reading. Try lowering the boost by at least 1psi..

Zisco are still going strong here in malta

Use toyota coolant .. the best. Check the thermostat by dipping it in water and a temp.. at 82°c it will start to open.. if nothing happens cjange thermostat

Aem or innovate.. pretty accurate.

You can remove the sensors and measure them.. then putting them in again

I IAT is bigger than 1/8 for sure.. but dont know the exact size

Anyone here fitted any gearbox to 4e apart from the g6 .. c56.. c52?? Maybe celicas or mr2 boxes.

I hear the engine running on idle but could hardly hear anything while i start driving.

I pushed the pipe intotye copper pipe.. than flattened the frond piece and drilled a hole.

I see. The listen up device is good but its picking too much interferance. Maybe i will try it with different wires as i used some normal speaker wires.

Anyone here have managed to make some Good detcans. U tried 3 methods and none if them is working. Tried flattening a copper pipe and attach everything to earmuffs.. didnt work.. tried an elctronic one using Listen Up device but the alternator frequency is the only tbing i can hear. Tried even using stetoscope but the sound is very low and i can barely hear anything while reving. I saw one live.. from a tuner using a stetoscope and i duplicate it but still no luck