Jump to content

Duduglanza

Member
 View Profile  See their activity

  • Content Count

    303

  • Joined

  • Last visited

 Content Type 

Everything posted by Duduglanza

  1. Duduglanza
    From Tail to turbosmart.. im not sure about that
  2. Duduglanza
    I think they will fit mate
  3. Duduglanza
    With those mods it will keep hitting fuelcut... set the actuator to .8 or else find an fcd..
  4. Duduglanza
    Try unplug it and see what the car does.. and if it runs ok check that you didnt switch wires.. make sure connections are good!
  5. Duduglanza
    What make?
  6. Duduglanza
    Just found it was an abs problem. One solenoid was stuck close. Few blows and all fine now
  7. Duduglanza
    Is there a way i can trigger the abs pump alone?
  8. Duduglanza
    Checked... all fine
  9. Duduglanza
    I was thinking about it.. but right now i prefer to leave it as it is..
  10. Duduglanza
    What should i do if air is trapped in the abs modulator since i left the master to empty itself while doing new fluid??
  11. Duduglanza
    Yes checked!
  12. Duduglanza
    I think air is trapped in the abs pump or master cyl.fluid has been drained out as the friend who was helping md out didnt top it up.
  13. Duduglanza
    Anyone may shed some light on how to bleed the full system.
  14. Duduglanza
    Anyone may shed some light on how to bleed the full system. I drained all the fluid.. im getting 3 bleeding right but the rear drivers side isnt bleeding at all and no oil is coming out.
  15. Duduglanza
    Coolant and air temp, and map sensor
  16. Duduglanza
    Anyone may shed some light on how to bleed the full system. I drained all the fluid.. im getting 3 bleeding right but the rear drivers side isnt bleeding at all and no oil is coming out.
  17. Duduglanza
    The bottom part to the intercooler piping and the top part to a vacuum from the intake.
  18. Duduglanza
    I cannot see why you are going braided on thd return line. Once out the regulator the fuel pressure is decreases a lot.
  19. Duduglanza
    Yes you can
  20. Duduglanza
    Yes you can use the white as lambda feed but you need to set the gauge on 'p4'( narrowband)
  21. Duduglanza
    Every car varies a bit.. that might be the problem for less boost than stated. Fof the aem just wire the red and black. The others are used only with aftermarket ecus nornally.
  22. Duduglanza
    intresting
  23. Duduglanza
    Anyone using Emanage ultimate have the same problems. When the engine is running and i plug the usb cable to emu the engine runs fully rich..without usb plugged just fine...
  24. Duduglanza
    Its alive and i dont know what was the problem! :/
  25. Duduglanza
    I dont run icv since i have custom intakE. Regarding sensors I checked them through my emanage data logger. Map , water , intake anc tps sensors are all working good and giving good readings. I will try a compression test then altough i cannot heat the engine
×
×
  • Create New...