enots

whats up with it at the moment??

i'll pop along to cardiff gate not going down to b+b was a nightmare last time they had one down there lol

i'll pop down its only down the road i doubt i'll be going for food though meant to be going for a meal with the misses later on

as long as we're still meeting at cardiff gate i'll pop along for a bit as its only 5 mins down the road i wont be making it the cruise though

ayeee i might pop down if its at half 3 cant stay for too long as i got stuff to do. this still at cardiff gate???

haha would have spun round for a chat missus was whining about food though and you'd gone by the time i came back past

think it was you dude parked up in safestore by mcdonalds? around 10 clock last night

hb3 are the bulbs i always buy when i need to replace any

where in south wales you from dude?? quite a few of us on here now

yeahh mines been fine never had any problems with it

i've got a sparco one which i bought from japfest looks the same as the above and its been fine

sundays are best for me as i work friday and saturdays but i'm up for a meet

i've just modified my hks actuator. fits perfect to be fair basically drilled a hole in the center of the bracket on there pretty much and then had to cut the arm a little so it was short enough to hold the wastegate closed

its just a ebay flocking kit mate lol just glue and powdery stuff basically

few people have asked me how i made this since i posted a pic in the gauge thread so thought i'd post some pics i took while making it was pretty simple considering i'd never used fibre glass sheeting before. list of things needed are basically below * fibre glass sheeting pack from halfrauds *filler * basic tools and patience lol so basically i cut out the vents in the centre console and wrapped my gauges in some cling film. i then took the fibre glass sheeting and wrapped a piece around the gauge and covered with the resin and let that dry took about ten mins. after doing three of these

just remove the locating pin think i just used a pair of pliers and pulled it out

built it with fibreglass and a skim of filler and then flocked it. the 3rd gauge is fine its just the angle i took the photo from i think because it was outside of the car.

or build them into the centre console

i've used muc-off in the past always brings it up well i found

from what i can tell its basically so you can change the colour of your wheels as in spraying them or having them powdercoated but you can return it to what they were originally by removing it. so you don't have to sand back the rims before applying it etc ( i think lol )

latest issue aint my car its JO'S LOL

^^^^ LOL i'm due a lot of fucking prizes then

pop to toyota down cardiff for coolant i went there the other week when i did my rad and he said they'd stopped stocking it but he'll check if they had any. managed to get 5 litres for a 5er as it wouldn't scan through on their system no more so he put it through as a litre of the new stuff

ah fair enough when i replaced mine the outer case of the bearing had come away from the bearing itself and wedged itself into the disc was a right pain to get out of the disc.

New bearing has to be pressed into the disc too getting the old one out of the disc is a right TWAT too lol