Jump to content

yaristurbo

Member
  • Content Count

    3120
  • Joined

  • Last visited

Everything posted by yaristurbo

  1. id try bocking of dump valve and boost gauge as a start, this may be daft early question but whats on your spark plug leads
  2. can the rear seats be swapped for the later?
  3. i know this is in chassis but... what are the differences between the two in the whole car? reason i like the 98 spec but 96 one has become avaliable
  4. hmmmmm... gearoil how id love to never smell that again lol
  5. make sure its cold start up if you do, be able to hear a knock before everything expands
  6. slight smear of silicone i tried the cereal box one, choco sqaures if i remember rightly
  7. no its tiny mate, depo looks same tho
  8. power---------- terminal --------- back of starter 10mm nut ---------------back of alternator 10mm nut earth --------------- terminal ------------------ chassis just at side of battery tray 10mm bolt ---------- gearbox bracket 14mm bolt thats for a gt
  9. might be able to order through TD or straight from depo the stud snapped off mine so let me know
  10. how old are the bc's top bearings? nothings catching with it beeing low? brake disc back plate when bearings got weight load on it? stone in caliper?
  11. any signs of fluid from master clyinder on bulk head or inside basically check all the hydralic system and if its not that then time to have box out mate and see whats lurking
  12. thats a big air leak to not cut out when covered, id have the manifold off on abench and block off everything that isnt used to double make sure bud, i kow my old setup a bolt was put in the hole for iacv i might have a valve one in garage if u want it? also if its unpluged will it defult to shut? havent messed around with these alot recently so may be barking up worng tree
  13. its the fuel cost for me, if a had a skyline i would want to drive it everywhere but obv would cost a fortune
  14. it could happen with a new one too tho luck of the draw think liam d does good service
  15. whip down pipe off housing will be full of it i guess, stem oil seal would leaking would burn in clyinder surely
  16. looks like this with out all shit http://www.ukstarletowners.com/topic/69776-cba-breaking-my-glanza-anymore/
  17. around that area is reverse light switch directly on top of gear box numerous water temp sensors on thermostat housing is bottom hose goes on there oil pressure switch is on the part of the loom front behind downpipe the gear box looks to be plugged in but the green on looks to be water temp maybe the one facing bulk head on thermo hosuing hope this helps
  18. pm me what you have must be not be siezed, will paypal
  19. yeh but whats in the futures houe and more cars lol
×
×
  • Create New...