fremyjay

How much you looking for

Nope check here http://www.jp-carparts.com/toyota/partlist.php?maker=toyota&type=121150&cartype=9&fig=6404

Wanted bolts for sunvisors,little black plastic clips parcelshelf clips into, drivers seltbelt

I feel bad for the guy, getting stung is a horrible feeling, but their are things in place to protect you when paying through things like paypal, so if you decide to not protect yourself for the sake of a few pennies then it's your own fault and too bring the forums name into it isn't necessary personally, just my opinion so no-one need take offense and if you do I don't care anyhow ;)

Gumtree or swapz bud

Don't I drove for 6 months with mine in the windscreen, pulled 6 times and never any bother, until one day I got pulled and fined £60 for not displaying my license correctly- just reread and you would need to be veryunlucky of its just one night but if they want to be cocks they can fine you

Best thing to do is take it back with the light so they know exactly which one it is

Hi if it's an ep91 you have two plastic bolt/ spiny bits, one at the top and one at the bottom unscrew them then literally pull them off, if it's an 82 I'm sure someone will come along as it might be different

Remove middle bracket only as glanza rear bench will use the two outer ones, as the 98 spec glanza has a split rear bench as I've just changed mine

There's a glanza on photobucket with angel eyes, you need to make them yourself though as they are not sold for the glanza

I spotted it straight away but I have my forged engine to pay for

pmsl I know who's all over this already

Mine was leaking behind the light where the weld joins, there was a lip and water seeped in there, siliconed it and no more water

Only good thing abouts halfords is their proffessional tool range and I don't mean their employees

Have you removed all 3 bolts yet??? You can push one side of the Speedo in and pull the other side out slightly to be able to get your hand in behind bud, just a matter of manouvering it slightly to get access behind, it's hard to get at the Speedo cable unless you have thin hands, I usually remove the panel below the steering wheel and reach up to the back of the Speedo, only problem is you can't remove your whole dash without removing the Speedo as some of the mounting points are directly behind it

You don't need to remove the dash bud, two screws at top of plastic around Speedo, then behind that there are 3 bolts holding the Speedo in, pull Speedo forward get your hand in behind and unclip the two wire looms and Speedo cable, then a bit of manouvering and you will be able to get the Speedo out, make sure your steering wheel is down as far as it can go

This has always been my favourite colour, so expensive though.... http://www.pinterest.com/pin/458874649502929372/

Damn internet here is awful, similar black to this with blue or red metallic flakes added into the paint to get a shine in the sun http://m.ebay.com/itm/390717378080

I'm on my mobile abroad atm so can't upload a pic but give me two seconds and I will upload a pic bud

If your going to go black again go for a darker black with some tint in the laquer

Set of 98 spec folding ones with all the brackets, can post

Alot of seats will fit but obviously you will need custom runners for them, if you are handy with a welder then you could fit pretty much anything

Yeah there's a company here that sells the stuff to do it at home in the bath

about time, no fucker is breaking anything atm

You might find you will get more help posting this in lifestyle forum bud, more people will see it