Jay85

As above guys, what you got?

He need a pint after licking 24 minges!!

PM browner on here dude, send some pictures and ask his opinion! He will prob be your best bet for parts too!!

Welcome dude!! I'm in kent too! Maidstone way!! Few of us about now!

Cheers dude! Only prob with the use is they want 500% extra to post to the uk!! Got one of rhd for a bargain!! Thanks tho!

Loving the polishing work dude!! And the addition of the oem alloys!!

Love mine!! Makes a hell of a lot of difference to the way the car drive IMHO, think mine is a cc's but rbz on here makes custom ones which are sick!

As above guys, any ideas where I can get one in the uk? Cheers

Does this actually fit the starlets??

Massively late feedback thought I'd posted it! Bought a HKS super sound bov and starlet specific tmic adapter! Awesome item, super fast (unlike my feedback) delivery and well packaged! Top seller, will deffo use again!

Bought a EP82 cooling panel and bonnet lift kit separately off of Jezza, threaded a bolt fitting the bonnet lift kit (I know impatient knob) should of waited until I had someone to hold the bonnet! Anyway Jezza kindly agreed to send another bolt when the cooling panels came in. Like a fool I forgot to remind him and as he is uber busy (just check out all the new products) he didn't include it with the cooling panel! Any way once I mentioned it to him, Jezza posted one out the next day free of charge and covered postage!! Customer service at it's finest! Highly recommend Jezza as a trader and his quality products!!

National shortage!!

I need the same!!

What a fu*king result!! It never ceases to amaze me the amount of power than can be got from these little beasts!!

Top pic is defiantly aircon, top of throttle body connects to a unit on the bulkhead and last pic it the coolant controlled choke for cold starts I think! That's all I can help with off the top of my head dude

Hey fella, I used to work in an exhaust centre! The best way I've seen is to cut the cat out and have flanges welded in place as when you use a sleeve/clamp set up, the top part of the clamp can cause a u bend across the width of the pipe and sleeve which is then a bastard seperate. Where if you flange it it's four nuts/bolts and two very cheap gaskets and you're done! I'm sure some people will disagree with me but it's the best way I've seen/done

Few more

No worries dude!

Here's a couple dude:

You know dunelm mill in Maidstone, where fmic used to be?? Say there at 8? Little green monster from on here will be there!!

Cheers guys! As I know they are meant to be there I'll have a butchers!!

Hi guys, having not replaced oem pads yet, I was wondering if there are retaining clips to stop the pad rattling as mine rattle their tits off!! Any insight would be helpful!

Tovil!! Not too far at all!! Fancy meeting up tomorrow?

Welcome dude, I'm in Maidstone! Where abouts are you? And get some pics up ;)

Been out with LittleGreenMonster aka batsyd (looks like syd from ice age but a tad more dynamic!) aka Jordan!! He left his oil cap off and ran the engine (like a plank) so we gave the bay some work! Not a bad result tbf: