5e colin

depends on ecu really some will go beyond 1bar tdo4 fit and check id go wepr anyday over any other company you will have lifetime warranty dont think you will be getting that from any other 1

there on ebay uk mate 13£ delivered look for corolla2 el51 :)

your last parcel didnt arrive yet not your fault there is a postal strike over ere for 4 days

yes it fits but there such a crap box totally useless go for any 5 pot instead car will pull faster with 5pot

niiiiiiice >>>>>>>>>>>>>>> some day some day for sure

you can slap a 4e head on the 2e they boost well they have strong rods in them

there made to last and are made exceptionally well i got some

tracing that wire is simple if its in the loom with a multimeter you can also test the dizzy https://www.youtube.com/watch?v=PUAd5K3OQV4

cheers adam jdmfreak i run 185/60/14 at 36psi at 32psi my car moves to much and my cornering feels sloppy ( car moving around )

what parts of the sensors etc etc did you use to run the gt loom i ran for over a year NA 4efte electronics and and 295cc injectors , passed nct emissions flying colors low idle 0.12% and high idle was only 0.01% you had a issue for the over fueling mate no turbo map or 02 sensor not connected or ecu temp sensor somthing like that anyways

td04 comp housing and prop fits on a tf but i think the core of the tf035hm needs to be machined where the comp. propeller sits on the housing there is also a bolt on upgrade that dont need machining but i cant find them on the bay

hey guys if i fit front uprated swaybar will it cure the pulling i get when crossing ruts and white lines ??

they can indeed

im on about there the same fitment amigo not the ratios ( box to engine mounting points )

thats not bad you can salvage al the cables pedals hydrolic line etc etc from the gl you will have al u need then

starlet gl manual yes al gearboxes on any Eseries engine will work 12345e you going converting her now to manual corolla 1.6 no diferent bel etc

i would just get your compressor wheel and housing upgraded to 19t on the tf035 you would gain like sooooo much more torque

what gen is your 5e if its gen1 it probly have fat rods and boosts very wel trow up a pic of the rods if you can if your lucky there fat and take a good amount of boost

just to ad to this thread i did it few years back and got the """" APEC DSK 2188 """"" al i had to do was cut 1.5mm of the inside hubface ( 4x100 ) and cut them down to 260mm now they bolted strait onto my hub without spacers and longer studs pure oem fitment they also fit under my 14" jdm wheels

from toyota yes there diferent material but from moterfactors no there the same i got 5e rings on my 4efte in 5e there available in 74mm 74.5mm and 75mm :)

^^^ no there the same cam

could that not bend now under hard braking ???? thats where al the stress ends up on that end of the wishbone

welcome kit that would be a nice project and 1 fast pocket rocket they weig even less then our cokecans

did that there again im getting soft parking brake pfff handbrake is pulled right up and lever arms on both calipers are both to the far front of the car brake pedal is solid i cant move the wheels attal then are my calipers fucked ????

small update swapped the pads around so now the niple is in the groove i unwinded them to where they just could not go on the pads then pushed them strait back a mm with a plate with a bolt tru pushing another plate that was lying on the piston so piston cant rotate backwards loose i hope but i think i will have to redo this procedure when the pads are bedded in again ??