Jump to content

richardc9052

Member
 View Profile  See their activity

  • Content Count

    1371

  • Joined

  • Last visited

 Content Type 

Everything posted by richardc9052

  1. richardc9052
    Yeah sorry I've been quite busy lately!
  2. richardc9052
    Seems like it. I can't see it happening if you swap them one at a time.
  3. richardc9052
    http://www.ebay.com.au/itm/272109417640
  4. richardc9052
    Would work out better to get those uprated springs for sale in Oz then. They are fairly cheap
  5. richardc9052
    It's OK I'm fairly sure I know
  6. richardc9052
    What company was it
  7. richardc9052
    185/55/14
  8. richardc9052
    Aren't ep70 hubs different. I've not had a chance to take the wheel off my car but take my word for it. They aren't like that lol
  9. richardc9052
    I have just found one in the shed. The back partis damage a bit but the rest is perfect. See pics:
  10. richardc9052
    Didn't get a chance to get that pic Colin. Maybe tomorrow
  11. richardc9052
    Start your car and disconnect the battery. Then try to cause the noise again.
  12. richardc9052
    If it doesnt rain tomorrow ill take a wheel off and take a pic as they sit.
  13. richardc9052
    lol lads i have them fitted to my car. they are perfect. They where also fitted to Johns twin charged ep90 and shams ep70 td04. Pluss jack kelly Uses the exact same setup. They are perfect.
  14. richardc9052
    yep direct replacement with td04
  15. richardc9052
    You can get an adapter harness made up! Check out Turbo Fevers thread. He is using one. He has the android app on a tablet in center console too which is pretty awesome. http://www.ukstarletowners.com/topic/95161-td05-billet-5efte-ep82-caged-ecumaster/
  16. richardc9052
    Ecumaster emu for that power with big cams. You can adjust injection angle which would help if you end up with large overlap
  17. richardc9052
    Ive got hairy balls
  18. richardc9052
    Exchange rate is awesome for us in the euro lol..
  19. richardc9052
    Just use ae111 twinpots with Mr2 vvti front disks. bolt on, not spacers,shims or drilling... Just a little grinding to the carrier
  20. richardc9052
    Haven't you seen the other thread regarding td products
  21. richardc9052
    I think they are all the same.. I was using a 1e pulley on my 4e
  22. richardc9052
    http://www.ebay.com/itm/191945329277
  23. richardc9052
    Theres no set length.. You have to figure it out through measurement with a little trial and error.
  24. richardc9052
    You could try the 86 mr2 paddle clutch from the USA with your pressure plate ( usa clutch comes with standard cover) As they are quite cheap and ive seen one holding 230bhp with the standard cover no problem.
  25. richardc9052
    Best bet is to measure the length of the standard one and set it to that height. You can then adjust until its centred by unbolting one end, adjusting and then refitting a few times. Or if you are any good at math, its basic trig.
×
×
  • Create New...