T-dog

https://www.ebay.co.uk/itm/181216209018

If I remember rightly the yellow black red white plug is for rears speakers ( there is normally the plug on the rear right behind trim worth a look unless some one has tapped it in to the foot well as the black electrical tape isn’t standard ) and the other plug next to it is for front speaker , 12v , 12+ . Ground . 👍🏼

90987-04002 This is the Toyota part number , loads on eBay 👍🏼

Bump

Bump

Anyone got a reserve bonnet scoop forsale ? Thanks

I've copied the how to do from toyotagtturbo forums this explains it better . ok u will need 12mm spannertiming light (about 15 pounds for one)some sort of white paint (tip x)ok first off look at the crank pully and find the marks on it mark them with the tip x so u can see it better like i have done , do the seam with the 2 marks on the lower timing covers as in the pix . next open the diagnostic port andd bridge out TE1 and E1 this places the car in diagnostic mode (when u start the car u will find your check engine light will flash) now set up the timing gun and place the clamp on cyl No 1 now start the car and shine the gun on to the lower pully (note if your gun has a dial on it set it to 0) u will be able to see what your timing is set at now. it should be flashing at the 10 marker if it not read on ok if its not flashing at the 10 marker losen the 2 12mm bolts on your dizzy as per the pix now ajust the dizzy untill your timing is set at the 10 marker (u will see the timing move as your ajusting it) once u have it at the 10 marker tightn the 2 12mm bolts up and just give it a last check to make sure its not moved.

You need to bridge te1 and e1 in the diagnostic box using a bit of wire then start the car then adjust and then set it to the 10 degree marker on the cover 👍🏼

Any vacuum leaks on the inlet ? . Silicone Pipe to map sensor all good ?

I’m sure the ac rely bridge was only on the gt turbo , I would check the wiring to the fan switch if you replaced the switch and check the relay try swapping it over with one of the others and see if that give you ideas to what’s going on 👍🏼

There was a guy on Facebook from Ireland that was doing them so worth a ask . Or like you say Japan or cut the feet off your standard ones and weld them on a universal seat frame 👍🏼

Ok mate private message me and we will sort it out 👍🏼

Anyone got any spare ? Thanks

Ok cheers mate the hunt is still on . One will pop up one day or a set 👍🏼

I've got them same kit on my glanza . Love them 👍🏼

Ok mate sounds good . we will do some searching about 👍🏼

Hi . I’m after a later spec glanza wing mirror ? Thanks Toby

No mate , very rare to get a set now

Trds

Sorry yeah just engine mounts all 3 of them. 👍🏼

I've got them on my car . Great mounts , I had power flex all round before them but It had terrible vibration . so I change them to the Trd ones and they are stiff but with no vibration 👍🏼

Ok mate that’s good to know for the future 👍🏼

What you doing with the 3 location bolts , just sealed them up ?

perfect mate 👍🏼