Johnboy GT

Where did you get it from bud? John

Hi Idrees I've spoke with Uzzy regarding this but thanks for following this up John

Everyone goes the opposite direction bud. Starlets aren't really classed as off road vehicles to warrant having a lift kit made John

Where abouts are you from bud? John

Another North East lad! Welcome along Gaj John

I've got one sitting at TD but there was corrosion between the compressor housing and exhaust housing. Not sure if it's of any use to you but can enquire about getting it back for you bud? John

I don't think these bulbs come out of the plastic plug? When I bought mine it was a hb3 I think. One type has one plastic slot on it and the other has 2. John

What side? John

Good progress bud! That wheels actually look smart on her John

If it starts to go anywhere above half then I would start questioning. The gauge doesn't tend t move a massive amount after the fan kicks in, just enough to bring it down to below where the fan would normally come on. As for sitting outside your house with it running I assume from cold, you will be hard pushed to generate enough heat to bring the fan on without putting the engine under load John

What temp are you classing as overheating? If the fan is kicking in and it drops the temperature then it's doing its job surely? John

I will donate tonight bud when I'm near a computer John

Are you running an lsd box? John

Dual core civic rad, slimline fan, anti freeze and low temp thermostat and haven't seen my gauge go anymore than a third of the way up John

Hi When I go to the product on your website it comes up that the product is not found. Have they been discontinued or is this a glitch in the website? Cheers John

Good base to start again with! Welcome back buddy. Drop me a PM with a price on the Grid Drifts John

Just out of curiosity do you have the two bolts that bolt the bottom part of a rear three point strut brace? John

I highly doubt it's your gearbox bud. Swap the clutch and see how you get on. John

Sounds like it's trying to engage the gear without full use of the clutch. So its stalling when you put it straight into third? Do you have another clutch to try I. E the one you removed? Or even to compare it with? John

In fact if I looked properly I would see there's a full set ha! Legend Rob thank you mate John

Will they fit the rear if they are advertised for the front Mr Bower? I did try looking on ebay but didn't have much joy? John

Bump

Rear brake pad retaining clips? John

Gator grip socket if not John

Just return no? Supply one is high pressure is it not? John