Jump to content

aidanep71

Member
 View Profile  See their activity

  • Posts

    411

  • Joined

  • Last visited

 Content Type 

Everything posted by aidanep71

  1. aidanep71
    Your filter relocation will need modification as will your hot pipe to the cooler, a decent clutch if ya haven't got one already, oil+ water lines for the turbo, wastegate/actuator if not included in kit. And yo will obviously have to get the fueling checked
  2. aidanep71
    Welcome
  3. aidanep71
    This maybe a stupid thought as I wouldn't no much about this but surely if each piston+rod set weight the same it would be fine as the crank will already have been done so should still be spot on
  4. aidanep71
    i would get the center box removed tbh those japspeed exhausts look s**t imo
  5. aidanep71
    I don't understand why ye change the top mounts there's no need at all
  6. aidanep71
    Ep82 or 91 complete struts fit handy depending on the hubs on your car some have 17mm bolts some have 19mm bolts if you already have hubs with 19mm bolts all that needs to be done is drill out the top mount bolts a tiny bit and the whole lot will then bolt on and then make a brake line bracket job done
  7. aidanep71
    Depends what cr pistons you got a got stock cr wiseco pistons and using a 1mm gasket to try keep the cr near stock
  8. aidanep71
    Hmmm might give this a go as my brakes are a bit weird sometimes
  9. aidanep71
    Was the master cylinder and servo a straight swap or did a few bits need modding
  10. aidanep71
    Gun metal grey
  11. aidanep71
    That would be cool haha
  12. aidanep71
    Looks the same bar the dirt of it just weigh them see if they're the same
  13. aidanep71
    There should be a small plate on the center housing somewhere where the oil feed goes with the serial number on it which will identify the turbo
  14. aidanep71
    It will loosen when your beating in a bigger size it's exactly what happened mine
  15. aidanep71
    Happened mine I just beat a slightly bigger torque into it and it flew out
  16. aidanep71
    Is there a wiring diagram on here for an emu thought I seen one before but can't seem to find it now
  17. aidanep71
    Someone must know something surely ??
  18. aidanep71
    After fitting the turbo leave the oil return off crank over the engine a few times with the efi fuse out and kink lead off until oil comes out the return then put everything back on and you should be ready to rock
  19. aidanep71
    Bump
  20. aidanep71
    just bought this in japan few weeks ago should have it shortly
  21. aidanep71
    have a new emb with new wiring looms and map sensor
  22. aidanep71
    Anyone on here using one thinking of using one on my ep71 just want to no what the lag and all is like with them All info welcome
  23. aidanep71

    gready emanage

    aidanep71 replied to marble's topic in Wanted

    Have a new emb with both new looms and a greddy map sensor
×
×
  • Create New...