turbo Grant

The end made me laugh haha

Beat them off with a hammer and screw driver. Just bend the bits back afterwards. As long as they are prepped properly before resealing it won't leak

Defiantly spray

That will fit on a starlet but if your wanting over 250odd you will need a forged engine

The gears are the same as the turbo c52 box but with a shorter 1st and possibly second? The final drive area is one that needs looking into

Another thing is you can't buy off the shelf diffs. Would need some thing custom or a phantom grip

Think you will be on your own with this one, only one way to find out

I would of haha

Yet every one runs pec rods now and they were classed as shit a few years ago

I would be happy to run a set

Well that's not on! How's changing the cluch going to affect warranty on an engine?

We had to stand next to the best car and block the others off haha

Tint spray will be spot on

Spray the oem ones job done. The heko ones are just push in and crap, put extra strain on your window motor causing that to die even quicker than the do

Not sure if an mr2 pump would fit in the wheel arch. But a saxo one would. Especially if you had a remote resiviour. But to be honest when I change my set up I'm going for a corsa c colum. Will be a bit of work to get it in but you can pick the ecu controllers up for peanuts

Got a couple more snaps of the car It has a few scuffs on the wings that need sorting. Suspect it's from when some oap's had it at some point An now for the worst bit of rust on the car!!!! Really bad for a 26 year old car Also fitted some GT seats and centre bit on Saturday Need to make a couple of brackets up for the centre bit as its held in by gravity right now

I've got a saxo pump with the buit in resiviour. I've just got mine on a flick switch so if I want to use it its there. The mr2 pumps are massive but so are the saxo ones

Sun visors?

I do not see what people see in that spoiler. I might change my mind when it's all painted. But I'm on the side line at the moment

The eBay bga stuff will do the trick. I would still use exhaust paste on it to seal it totally. Other wise you will have another blown gasket. I made a copper gasket for my old waste gate. Was only about 1mm thick

Make a copper one with lots of exhaust past. Will be perfect then

Where are you based?

I've done 600 miles in this car so far. It's so funny to drive. Need to start stripping the paseo down and swapping the shocks and springs over. Fit my GT front anti roll bar. Rebuild the 5e and sling a turbo on it. Been wanting another starlet for a daily for a long time now. Will get a load more pics tonight. Seriously slacking on. The pictures with this one

Any one got pics of the ep70 and the flux girls at the end

I'm after some good ep82 sun visors. Not floppy ones with broken wires. And I need a read quarter interior trim. This is the pattern I'm after Let me know what you have!