Jump to content

AdamB

Member
 View Profile  See their activity

  • Content Count

    4340

  • Joined

  • Last visited

 Content Type 

Everything posted by AdamB

  1. AdamB
    If you can't afford it mate just wait, a good ebc can make all the difference. I dont like the blitz ones, apexi avcr goes well second hand or a hks evc do the job. Why dont you just run base spring pressure? You get all the springs with tial gates.
  2. AdamB
    Have you checked the valve timing and ignition timing. If these have been retarded by like 2 degrees you'll lose a fair amount of peak power.
  3. AdamB
    Providing it works properly, maybe just keep an eye on it for a few weeks.
  4. AdamB
    Good stuff mate, enjoy
  5. AdamB
    Personally I would rip it out, at that kinda fuel pressure and no safety cuts it would only take a slight change in fuel temperature to run the engine lean. Unless it was brought from a trusted source with proof its always going to be debateable and leave ?? in your mind, all for some jdm points.
  6. AdamB
    Hmm I couldn't tell you if its fake or not, but running 4 bar of fuel pressure will be putting a lot of strain on the fuel pump. I would probably swap it for another fpr, why did you swap from the fse?
  7. AdamB
    You sure theres no vac leaks? Why do you need 4 bar of fuel pressure?
  8. AdamB
    Bump
  9. AdamB
    If the engine is a 4E then run it at 4E marks, if its a 5E run at 5E marks. Best way is to dial them in with a DTI though.
  10. AdamB
    The front is more personal preference, because it stiffens the front end up it can create more understeer.
  11. AdamB
    Throttle position sensor mate. Check here for the setup http://www.toyotagtturbo.com/forums/showwiki.php?title=TPS+throttle+position+sensor+set+up+procedure And here for the ignition timing http://www.toyotagtturbo.com/forums/showwiki.php?title=How+to+set+timing
  12. AdamB
    Try setting up the TPS mate.
  13. AdamB
    Looking good mate, can't wait to see your zisco bits
  14. AdamB
    Checked the cam timing? Checked the ignition timing?
  15. AdamB
    No it won't cause any harm but us just annoying. You may have mixed up some of the shims as well.
  16. AdamB
    Tbh it does seem too good to be true, but will find out
  17. AdamB
    Lol anytime mate
  18. AdamB
    Going to see this tomorrow as the guy is busy in the morning and im busy this afternoon lol. Will let you know how it goes
  19. AdamB
    Yes mate E1 and TE1
  20. AdamB
    I'd set the TPS first, but remember that it has to be in diagnostic mode to set.
  21. AdamB
    Guy won't pick up, return calls or texts mate Not exactly the best way to sell a car.
  22. AdamB
    Its a shame the guy won't pick his phone up as I was gonna go buy it tomorrow for the mrs!
  23. AdamB
    Yep they both use the same mounts.
  24. AdamB
    Same engine bar some sensors. The early GT engine has thicker rods which are supposed to be better than the glanza rods.
  25. AdamB
    I believe the studs which hold the cover on is actually a part of the cam cap. You'll need to get the cover off and order some new studs from Toyota.
×
×
  • Create New...