daniel_g
-
Content Count
10875 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Everything posted by daniel_g
-
My 3dr corolla is pre facelift so does look quite shit if am honest lol
-
How has the starlet scene changed since you joined??
daniel_g replied to fremyjay's topic in Lifestyle General
Yeah the starlet scene has become a bit shit over the last year or 2 i feel Theres still a heavy following and a busy forum and massive turnouts to shows so not all bad Although, too many of these cars are falling into the wrong hands. -
X2 Ive a purple T reg one as a daily just now.
-
I wouldn't even buy a running starlet let alone a 'built' one lol. Good luck with the search though buddy
-
Really nice seats, think theyre called speed confettis or something ??
-
Best thing to do would be to get an oil pressure gauge.
-
Would check the wiring to the oil pressure switch, if its alright then try another switch. TD apparently use new oil pumps on all the forged builds.
-
They do normally but Advances are rarely for sale.
-
Origami
-
Yeah its pins 8 & 9 on the 26pin connector.
-
Can i hear pops and bangs in there lol ? Makes me think youve an ignition related fault, dizzy cap, rotor arm something like that.
-
It gets a signal from the dizzy. Does the car actually rev over 3k and the dials dont show it ? Or will it not rev higher than 3k ?
-
It should only be a couple of sensors on the thermostat housing, depends if you have a 96 or 98 spec. I came across a different knock sensor a few days ago aswell, could have been a MK1 GT one but fuck knows.
-
This is absolutely crying out for a manual conversion and a tidy up !! http://www.gumtree.com/p/cars-vans-motorbikes/toyota-starlet-gt-tubo-advance/1069161232
-
Debatable.
-
Yeah i did find it a bit funny but had to put it on mute as their voices went right through me.
-
It wasnt for a dogbox was it lol ?
-
Ad give it a go anyway lol.
-
Yeah you use both 4paw box mounts. You dont even need to swap the engine, just bolt a turbo onto it
-
Maybe worth a gear oil change. Problem may lie in the suspension & steering components as Morgey said, or even tyres.
-
Jap size is 13x7" it fills the recess nicely, or you can run a smaller plate like a 12x6" and put it to one side.
-
Checked cables arent siezed ? Remove them from the top of the box and manually select gears with the selectors, see if they go in ok.
-
Meh ok driven a few in work, there are defo much better small cars for the money. I heard they were doing an RS version but duno if that came about or not. The wee Twingo 133 is far better to drive
-
That ones a stunner