5e colin
-
Content Count
6604 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Everything posted by 5e colin
-
they only way i see diferent is in the pirate/spuriouse bearings some are made from wax and some are really like steel depends wich you get that will last like the tiaho for 4e there super strong i use them for all 4e/4et , pitty they dont for 5e ( atleast i havent found them yet )
-
ay poooost is slow not your fault mate there just lazy fuckers 5 to 7 usually !!!
-
probly because they want to charge more ???
-
im very sure :) 5efe and 5efhe bearings are the same """" unless """ you go toyota email a bearing suplier they will give you the info same as 4efe and 4efte are the same bearings ( taiho )
-
so great to deal with !!!! , items are in excellent condition , and mint after a good wipe with spirits :) will buy again of this guy
-
can leave them off but ct9 wont last long they already suffer with the water connected
-
there the same bearings my friend
-
ebay.com or local moterfactors
-
turn boost down 1/4 turn to compensate for the extra air its getting no more fc
-
u wont notice it mate !!!! only dyno can will see the diff if swapped back to back ( the half inch pipe diference in short size route !!! )
-
^^^^^ bollox thats wrong that screan is supposed to be there !!!! lads how do i do it soo u see the vid in my pooooost ?????
-
^^^^^ indeed https://youtu.be/cXd155v8Z5U
-
as above anywhere/1 sells see tru dizzy caps for out 4efte :)
-
drum and disc same bearings paseo cynos starlet
-
DAAAAM that battery is small how long will it last without the engine running and lights on 5 min ???
-
toyota will be your only bet the sel by conrod not by set
-
was reading up on this last night if they are indeed 74mm then they are from the g13a they use 74mm bore how hard where you boostin this blck grant ???
-
hey guys how much is 203 wheel horespower in actual engine power at the crank ????????
-
they are indeed CAST g16A pistons ( 8 volve ) pistons and there .5 over size so there deffo not 74mm as far as i can see/find !!!! measure again grant
-
they look like cast pistons no ???
-
latest run around Evo 4 dead already
5e colin replied to Glanza-Ben's topic in Other Motors Progress Blogs
thats fucked up -
thats a utter crap way of doing it ^^^^ the ecu aint mapped for the raised revs !!!
-
GT TURBO rocking the glanza limiter 7.5k nice cheap upgrade !!!!!
-
if urs is p9 then yes but its not only ecu you need loom and coil/igniter/dizzy setup aswell as they are external coil you will have a 7500rpm limiter now you can start messing with it experimenting and when you get sick of it just slap turbo on it
-
i think its clever how you can look up al that shit ha ha just have to know where and how ???
