Johnboy GT

Can't beat a quattro A4 for a luxury daily. Run an 02 1.8t quattro myself. Can't fault them! John

Have to be a smaller profile tyre then by the sounds of it bud John

What offset is your wheels? You could fit spacers to help this in the mean time? John

I would have thought 150 across all four was pretty good although lower than new. Try a different compression tester and your leakdown test and see from there bud? John

Fantastic looking car. Subtle and clean! John

Take a look at Corey's Glanza. You will probably like it alot John

Projects are never finished. Just enjoyed for a period of time before another lurid idea comes around! Looks the dog's danglies John

I was actually looking at the same last night. Speaking with a biker I work with I was told that it's better to go for a carbonglass or fibreglass helmet appose to a thermo plastic helmet. Thermoplastic helmets tend to bounce if you have an accident which would hurt your neck etc. Shoei only make fibreglass/carbonglass one's also. Good to shell out for a decent helmet rather than saving cost here for obvious reasons. Cheers John

Hmm I put 1.9l? John

Soapy water spray on all the joints and let it run whilst you check them all. See if you have a leak John

Good point pal John

Yeah I was just mentioning it incase it was buddy John

Jay Grainger is looking for an engine bud! John

Was there something about Forged builds doing this when they were cold or did i imagine that piece of information? John

Not to sound daft, but did you prime it before hand? John

You can buy a new HDI intercooler for a ct9 for about that price bud John

Out of curiosity when you weld or bolt in the mount to the chassis, do you have it in line with the soft medium or hard setting? Am I correct in saying soft? Cheers John

Good progress bud! I like it! John

Going against the general consensus here. I will be having the Starlet, my Audi and my van on the road at the same time. Van for work, Audi for me and the wife's excursions and the Starlet for my pleasure. If you can afford it go for it John

These side bars don't fit with a cage and n do they? Sure I read that somewhere previously? John

That sounds like a handy bit of kit. I can definetly see the need with being so light on the rear they tend to hop if you come into a corner a bit hot! I agree, craftsmanship on projects are a great thing but few and far between. If the had the machining tools etc I would be doing a lot more myself. Anything I can do, I do myself. Keep up the good work mate. John

I like where you have gone with this Shaun! It looks good. How have you set up the brake bias? John

Ah wasn't sure mate. Cheers! My opinion though I'd say a K20 in a Starlet would take a bit of doing but not impossible. John

Well I bought mine for £100. Seen a few for £100 aswell. John

Is there not a lad on here doing that? Or is it a B series he is putting in? John